Enter your search terms
Submit search form
Web
examineonline.googlepages.com
Online Exam
>>
COMPTIA
>>
A+ Core
>>
Test 10
Menu
Programming
COMPTIA
GMAT
English
IQ
DataBase
OS
MCSE
CISCO
Finance
Management
Health
Soft Skills
Web Building
Multimedia
Test 10
1 . Your customer calls and reports that her computer shuts down and reboots on its own. What is one possible cause?
A.
The power supply is not providing enough power to the system
B.
The BIOS is set to reboot automatically every day
C.
Her external SCSI CD-RW is using too much power
D.
The CMOS is configured to cycle power at a certain time
2 . Which device is used to extend the 10Base2 network beyond the maximum distance?
A.
Repeater
B.
Converter
C.
Expander
D.
Extender
3 . Which equipment of the following means that the NIC and network equipment are set up so that they cannot send and receive at the same time?
A.
Single Duplex
B.
Paused Duplex
C.
Half Duplex
D.
Switched Duplex
4 . What would definitely cause an IDE hard drive to be damaged?
A.
Connecting to a defective power supply that only gives five volts on the 12volt line.
B.
Connecting one end of the IDE cable the wrong way
C.
Forcing the IDE cable to the floppy drive connector.
D.
Using the Y splitter where the 5- and 12- volt connectors are switched on one end.
5 . What should be used to extinguish a computer fire?
A.
Fire hose
B.
Class C extinguisher
C.
A silver foam water extinguisher
D.
Class A extinguisher
6 . ISA card should work in which bus slots? (Choose two)
A.
PCI
B.
AGP
C.
ISA
D.
EISA
7 . You just installed a Pentium II 800-MHz chip. When you booted up your computer, it only recognized 400-MHz chip. What could be the problem?
A.
Only half of the chip is installed into the socket.
B.
The jumper settings on the chip are not correct.
C.
The BIOS setting is not reflecting a multi-speed setting.
D.
You do not have enough space on your hard drive.
8 . MicroDIMM has how many numbers of pins.
A.
272
B.
72
C.
128
D.
144
9 . How should you open the tray on an inoperative CD-ROM drive?
A.
Insert a paper clip into the CD drive eject hole.
B.
Right-click the CD icon and select Eject.
C.
Push in on the lower-right corner door.
D.
Push the eject button.
10 . A customer just installed a new CD-RW. The system was working fine before the installation, but now the CD-RW does not work. What should you suggest that the customer do?
A.
Check the jumper settings on the CD-RW
B.
Check the CONFIG.SYS setup
C.
Add CD_RW in the device manager
D.
Flash or upgrade the BIOS
11 . When you arrive at the customer's desk the computer is giving a continuous beep noise that will not stop. What is the problem?
A.
A virus was downloaded from the Internet.
B.
In proper driver was loaded on the hard drive.
C.
The BIOS on the motherboard was corrupted.
D.
A key on the keyboard is stuck in the down position.
12 . What is the memory contained inside the CPU called?
A.
VIRTUAL
B.
CACHE
C.
ROM
D.
RAM
13 . What do you need to do when replacing the motherboard in a portable computer?
A.
What do you need to do when replacing the motherboard in a portable computer?
B.
Ensure that the board is AT or ATX.
C.
Ensure that the board is from that manufacturer the boards are interchangeable.
D.
Any motherboard will act as long as it is specified for a laptop.
14 . What is the main difference between AT and ATX motherboards? (CHOOSE TWO)
A.
PS/2 port
B.
Soft power switch
C.
Serial connectors
D.
BNC connector
15 . A service technician is trying to install two IDE drivers as master/slave on the same ATA port. Drive 1 installed first, jumped as a master and the BIOS correctly auto detected it. Drive2 was then jumped as a slave and installed but the BIOS would not auto detect it. Which of the following would be the next logical step to trouble shoot the problem?
A.
Configure drive 2 as a master with no slave.
B.
Replace drive 1.
C.
Replace drive 2.
D.
Make the CD-ROM drive the slave.
Test Name :
Test 10
Category :
A+ Core
Number of Question :
15
Pass Score :
80
Test Result
Your Score :
Passing Score :
80
Result :
Copyright by
VanTuMinh
© 2007
